2003/07/16 ( 1 / 4 ) NJU7007/08 low power and low offset voltage super small-sized single c-mos operational amplifier general description package information the NJU7007/08 are super small-sized package single c-mos operational amplifiers operated on a single-power- supply, low power, low offset voltage and low operating current. the input offset voltage is lower than 4mv, and the input bias current is as low as than 1pa, consequently very small signal around the ground level can be amplified. the minimum operating voltage is 1v and the output stage permits output signal to swing between both of the supply rails. furthermore, the NJU7007/08 are packaged with super small-sized sc88a, therefore it can be especially applied to portable items. features pin configuration low offset voltage v io =4mv max single low power supply v dd =1.0~5.5v wide output swing range v om =2.9v min @ v dd =3.0v low operating current (see line-up) low bias current i ib =1pa typ compensation capacitor incorporated package outline sc88a c-mos technology line-up (v dd =3.0v,ta=25 c) parameter NJU7007 nju7008 unit operating current 15 200 ua(typ) slew rate 0.1 2.4 v/us(typ) unity gain bandwidth 0.2 1.0 mhz(typ) equivalent circuit NJU7007f3 /nju7008f3 (top view) in+ v ss in- v dd out 1 2 34 5 v dd in- out in+ v ss
2003/07/16 ( 2 / 4 ) NJU7007/08 absolute maximum ratings (ta=25 c) parameter symbol rating unit supply voltage v dd 7.0 v differential input voltage v id 7.0 (note1) v common mode input voltage v ic -0.3~7.0 v power dissipation p d 250 (note2) mw operating temperature topr -40~+85 c storage temperature tstg -55~+125 c note1) if the supply voltage (v dd ) is less than 7.0v, the input voltage must not over the v dd level though 7.0v is limit specified. note2) the power dissipation is value mounted on a glass epoxy board in size of 50x50x1.6 millimater. note3) decoupling capacitor should be connected between v dd and v ss due to the stabilized operation for the circuit.
2003/07/16 ( 3 / 4 ) NJU7007/08 electrical characteristics NJU7007 (v dd =3.0v,r l = ,ta=25 c) parameter symbol conditions min typ max unit input offset voltage v io v in =v dd /2 - - 4 mv input offset current i io - 1 - pa input bias current i ib - 1 - pa input impedance r in - 1 - t ? large signal voltage gain a vd 60 70 - db input common mode voltage range v icm 0~2.5 - - v v om1 r l =1m ? v dd -0.1 - - v maximum output swing voltage v om2 r l =1m ? - - v ss +0.1 v output source current i oh v o =v dd /2 7 12 ua common mode rejection ratio cmr v in =v dd /2 55 65 - db supply voltage rejection ratio svr v dd =1.5~5.5v 60 70 - db operating current i dd - 15 25 ua slew rate sr - 0.1 - v/us unity gain bandwidth ft a v =40db,c l =10pf - 0.2 - mhz nju7008 (v dd =3.0v,r l = ,ta=25 c) parameter symbol conditions min typ max unit input offset voltage v io v in =v dd /2 - - 4 ma input offset current i io - 1 - pa input bias current i ib - 1 - pa input impedance r in - 1 - t ? large signal voltage gain a vd 60 70 - db input common mode voltage range v icm 0~2.5 - - v v om1 r l =50k ? v dd -0.1 - - v maximum output swing voltage v om2 r l =50k ? - - v ss +0.1 v output source current i oh v o =v dd /2 100 200 - ua common mode rejection ratio cmr v in =v dd /2 55 65 - db supply voltage rejection ratio svr v dd =1.5~5.5v 60 70 - db operating current i dd - 200 400 ua slew rate sr - 2.4 - v/us unity gain bandwidth ft a v =40db,c l =10pf - 1.0 - mhz
2003/07/16 ( 4 / 4 ) NJU7007/08 typical characteristics (1)NJU7007 (2)nju7008 [caution] the specifications on this data book are only given for information , without any guarantee as regards either mistakes or omissions. the application circuits in this data book are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. output voltage vs. output current (source) 0 1 2 3 4 5 6 0.01 0.1 1 10 100 1000 10000 output current (ua) output voltage (v) v dd =1.0v v dd =3.0v v dd =5.0v output voltage vs. output current (sink) 0 1 2 3 4 5 6 0.01 0.1 1 10 100 1000 10000 output current (ua) output voltage (v) v dd =1.0v v dd =3.0v v dd =5.0v output voltage vs.outputcurrent (source) 0 1 2 3 4 5 6 0.01 0.1 1 10 100 1000 10000 output current (ua) output voltage (v) v dd =1.0v v dd =3.0v v dd =5.0v output voltage vs. output current (sink) 0 1 2 3 4 5 6 0.01 0.1 1 10 100 1000 10000 output current (ua) output voltage (v) v dd =1.0v v dd =3.0v v dd =5.0v
|
